Show whole topic May 24, 2012 7:58 am
Julian Offline
Member
Registered since: Dec 04, 2007
Location: Belgium


Subject: Re: T8 and G9 Gear Box
Just a little note to say we have just received another new batch of gear sets and to remind people that "if" rebuilding these boxes, remember to change ALL bearings at the same time, and I don't just mean the roller and ball bearings, I also mean the bronze bearings on all of the main shaft and some lay shaft gears. these always show too much wear when we inspect them and this causes excess load on the double helical gears and hence your teeth falling off ;o) Generally the shafts are overly worn too, Therefore our sets come as a complete set "Including" all 4 shafts, input, output, Lay and Reverse. and all bearings and seals. Price eg, T8 sets are priced at 4800 Euros which is just under 4000 GB pounds, these are available for collection at either Bishop Grey in Aldermaston or Terry Formhalls Engineering in Southampton area.
Or we can drop them somewhere on our travels about the UK and Europe and if on our route it will be at no cost!

Regards,
Julian

Regards,
Julian