Show whole topic
Nov 19, 2008 8:43 am
Nov 19, 2008 8:43 am
Subject: Re: SU carburettor float levels
Here are two photos sent by yted, the left one shows the situation in my car, the right one is with equal levels which I think is correct. I measured my lower float chamber bowl again and found that the difference is in the distance from top of the bowl to top of the mounting arm.
As long as I do not find the correct bowl, (total height 70mm, distance between top of bowl and top of mounting arm 50mm, distance between middle of bowl to middle of mounting hole 60mm), I will make an extension ring to fit ontop of the lower bowl.
Attachments:
Here are two photos sent by yted, the left one shows the situation in my car, the right one is with equal levels which I think is correct. I measured my lower float chamber bowl again and found that the difference is in the distance from top of the bowl to top of the mounting arm.
As long as I do not find the correct bowl, (total height 70mm, distance between top of bowl and top of mounting arm 50mm, distance between middle of bowl to middle of mounting hole 60mm), I will make an extension ring to fit ontop of the lower bowl.
Attachments: