Show whole topic Oct 17, 2017 8:30 pm
Mark Offline
Member
Registered since: Feb 05, 2009
Location: Worcestershire


Subject: Re: 2 Litre Water Pump
Hi Steve
If I recall correctly, the water pump is removed by using a C spanner to remove the clamping ring that holds the pump to its mounting casting. If you do not have a C spanner then use a small diameter brass drift and with a hammer tap the ring back anti clockwise until it clears the thread. You can then withdraw the pump, but I cannot remember if you need to remove the carburetor and inlet manifold in order to allow the pump to be withdrawn towards the rear.

Of course in replacing the corroded water elbow the Lagonda Club can supply one of these and a side plate if that is also corroded which is more than likely ( I had to replace all the water jacket castings on my 2 Litre) Also, as mentioned by David, the club have produced a Vintage Lagonda Manual which is very detailed about all aspects of running all the 2 Litre models and a must for owners as the advice contained in it can save you substantial sums.

Once you have joined or if already a member, do give me a call (Y2 in the members register) as I think I have an original 14/60 owners handbook if that is of help to you.

Best Regards
Mark