Subject: Re: castor angle
Easy,
1. I hope you mean "Camber" angle as Caster is set by the springs and or adding wedges to the platform mountings on the axle.
2. Camber should be between 2 and 3 degrees from the vertical, I have seen and measured both. outside these figures usually means it's either bent or been modified.
3. Caster should be between 3 and 5 degrees but you will need to experiment as different wheel / tyre / car combinations may have wheel wobble which can be remedied with a change of caster.
Start with 4 and see what happens.
Regards,
Julian
Julian Messent