Lagondaforum

Hello Guest! (New posts) Forum


Expand and collapse Topic Options
Pages (1): [1]
 Show first unread post

Dec 24, 2014 4:35 pm
davidbracey Offline
Member
Registered since: Aug 10, 2012
Location: Maidstone, Kent


Subject: LG45 dimensions needed for trailer
A plea to any other LG45 owner.

I am looking to buy a covered trailer and it seems sensible to make sure it is suitable for moving any of my cars. The smaller ones are no problem but the LG45 saloon is going to be a snug fit. At the moment my engine is still out of my car (please don't ask how it's going) so the front is sitting higher than it should and dimensions are therefore inaccurate.

Could someone please measure the front top edge of the bonnet/radiator, I would like to know the height and also the distance from the most forward point. Also the width the the bonnet at that point please.

The trailer is a eco-trailer velocity RS. If anyone has one I would be interested to know what they think of it.

Thanks, and Happy Christmas etc. to all my fellow Lagonda lovers.

David
David Bracey
 

Dec 31, 2014 11:54 am
davidbracey Offline
Member
Registered since: Aug 10, 2012
Location: Maidstone, Kent


Subject: Re: LG45 dimensions needed for trailer
I'll supply a tape measure if it helps...
David Bracey
 

Jan 01, 2015 12:03 pm
DavidLG45 Offline
Member
Registered since: Dec 05, 2007
Location: -


Subject: Re: LG45 dimensions needed for trailer
Hi David,

I think it's a little unclear what you're asking to be measured. A diagram would help. . . .
 

Jan 01, 2015 6:03 pm
davidbracey Offline
Member
Registered since: Aug 10, 2012
Location: Maidstone, Kent


Subject: Re: LG45 dimensions needed for trailer
Yes, sorry if it wasn't clear. I've attached a very rough sketch of the dimensions I am hoping for and am grateful for any help.

Thumbnails of attached images:

Filename: LG45 Dimensions needed (small version).jpg
Filetype: File Type Information for: jpg jpg
Downloads: 343
Filesize: 29.43 KB
Image size: 535 x 295 Pixels


David Bracey
This post has been edited 3 times. Last edit on Jan 01, 2015 6:06 pm by davidbracey.  

Jan 01, 2015 11:01 pm
Bill Inglis Offline
Member
Registered since: Dec 06, 2007
Location: -


Subject: Re: LG45 dimensions needed for trailer
Hi David
Re the measurements you’re looking for, I measured ours, and referring to your drawing, I got A=46.5 ins, B=19 ins, C=19.25 ins.
Our LG45 is also an SB1 saloon. I did admire the photos of yours in the Club website gallery. Our chassis number is 12059, only four away from yours. Perhaps they were almost side by side when being built at Staines.
Kind regards and best wishes for 2015, Bill Inglis
 

Jan 02, 2015 7:45 am
davidbracey Offline
Member
Registered since: Aug 10, 2012
Location: Maidstone, Kent


Subject: Re: LG45 dimensions needed for trailer
Thanks Bill and David.

Bill, it seems quite probable that they were made at the same time doesn't it. Glad you like the photos - it's been a labour of love to restore. Once we have finished the engine rebuild I'm looking forward to actually using it and getting some satisfaction in return!

Best wishes,

David
David Bracey
 

Pages (1): [1]


All times are GMT