Lagondaforum

Hello Guest! (New posts) Forum


Expand and collapse Topic Options
Pages (1): [1]
 Show first unread post

Dec 30, 2014 6:32 pm
alanelliott Offline
Member
Registered since: Dec 29, 2007
Location: -


Subject: 2 Litre Flywheel Ring Gear
My ring gear is very badly worn, resulting in frequent jamming of the Bendix starter. I intend to fit one of the new ring gears which the Club produced some 25 years ago, when John Oliver was Spares Registrar. (Fortunately I bought one at the time!) I understand that the existing worn teeth must be machined-off the flywheel, and the new gear fitted, with the circle of twelve 0.312" dia bolts. But should it be shrunk on as well? Has anyone had experience of this job? Are there any points to bear in mind? Any advice would be very welcome. Alan Elliott
 

Jan 06, 2015 12:26 pm
Peter S30 Offline
Global Moderator
Registered since: Nov 27, 2007
Location: Germany


Subject: Re: 2 Litre Flywheel Ring Gear
Dear Alan,

without personal experience: I would assume that 12 bolts and the ring machined so that it is centered without play should be good enough, then there is only shear force on the bolts, I don't see any reason to shrink it on. May be this statement helps to start a discussion or to get confirmation.

By the way I love reading your book: Lagonda Journey - Fifty years of Vintage Motoring
 

Jan 07, 2015 1:10 pm
ray sherratt Offline
Member
Registered since: Jul 05, 2012
Location: wirral cheshire


Subject: Re: 2 Litre Flywheel Ring Gear
The ring gear on 2.6/3ltr Lagonds aren`t shrunk on, they are
a tight fit on an external diameter machined on the flywheel.
There are 6x 5/16" bolts attaching it pluss the clutch to the
flywheel. Does the ring gear fit purley onto a flat face without
some form of spigot.
Ray.
 

Pages (1): [1]


All times are GMT (Summertime)