Show whole topic
Oct 26, 2010 11:06 am
Oct 26, 2010 11:06 am
Subject: Re: DB3l engine back in !
Thank you Mike and Barbara. I hope it is as good in the long run as it looks.
Work goes on, I am making new copper tubes for the water supply to the heater (my engine had only rubber hoses going across the engine head which is not how it was when new). And I changed the little outlet from the oil filler (which is for breathing of the engine and I assume also for evaporating water that somehow comes into the oil?) I did not like that it would drip exactly on the ignition coil so I made a different one (the bent tube is from parts for heating system piping from my local DIY shop). The black is the old one.
Attachments:
Thank you Mike and Barbara. I hope it is as good in the long run as it looks.
Work goes on, I am making new copper tubes for the water supply to the heater (my engine had only rubber hoses going across the engine head which is not how it was when new). And I changed the little outlet from the oil filler (which is for breathing of the engine and I assume also for evaporating water that somehow comes into the oil?) I did not like that it would drip exactly on the ignition coil so I made a different one (the bent tube is from parts for heating system piping from my local DIY shop). The black is the old one.
Attachments: