Show whole topic
Apr 05, 2011 5:44 pm
Apr 05, 2011 5:44 pm
Subject: Ignition timing
How do you do the setting of the ignition timing of your 3ltr ? There is a hole in the casting where I can see the teeth of the flywheel but no marking, the ends of the screws fixing the clutch basket can be seen and may be could be used for this. But it is not very practical from below the car. So I made a mark for TDC on the pulley and fixed a pointer and I can flash it from above. Remarks or recommendations ?
Attachments:
How do you do the setting of the ignition timing of your 3ltr ? There is a hole in the casting where I can see the teeth of the flywheel but no marking, the ends of the screws fixing the clutch basket can be seen and may be could be used for this. But it is not very practical from below the car. So I made a mark for TDC on the pulley and fixed a pointer and I can flash it from above. Remarks or recommendations ?
Attachments: