Show whole topic
Aug 08, 2011 7:49 pm
Aug 08, 2011 7:49 pm
Subject: Re: G9 gearbox
Hello Julian
Only just picked up your reply about the vibration. Many thanks.
I am mystified as I made up a shaft which went from the inside of the flwheel bush to the centre of the gearbox input shaft (the shaft was pointed at this end and nudged inside the centre of the input shaft). The diameter of the shaft was a nice fit inside the centre of the thrust bearing in the centre of the clutch. I then trued up the gearbox top face with a spirit level - having first of all made certain that the engine was completely horizontal to the ground.
I will have to go back and check everything all over again - unless of course I have missed something with my system...!
Many thanks again.
Bill
Hello Julian
Only just picked up your reply about the vibration. Many thanks.
I am mystified as I made up a shaft which went from the inside of the flwheel bush to the centre of the gearbox input shaft (the shaft was pointed at this end and nudged inside the centre of the input shaft). The diameter of the shaft was a nice fit inside the centre of the thrust bearing in the centre of the clutch. I then trued up the gearbox top face with a spirit level - having first of all made certain that the engine was completely horizontal to the ground.
I will have to go back and check everything all over again - unless of course I have missed something with my system...!
Many thanks again.
Bill