Show whole topic
Jun 07, 2013 2:58 pm
Jun 07, 2013 2:58 pm
Subject: Re: Water Pump Modification
Thanks for advice Ray, very helpful.
David, did you once mentioned something about the seal which runs around the gutter in the engine bay? I was thinking that the original seal could be swapped for a low profile finisher instead, this would create quite a large gap for the warm air to escape out of...?
Thanks for advice Ray, very helpful.
David, did you once mentioned something about the seal which runs around the gutter in the engine bay? I was thinking that the original seal could be swapped for a low profile finisher instead, this would create quite a large gap for the warm air to escape out of...?