Show whole topic
Oct 20, 2013 2:16 pm
Oct 20, 2013 2:16 pm
Subject: Re: New wiring loom for V12 drophead coupe
Laurence,
Instead of removing the loom you can always document the loom by creating a loom tree noting where the important components are and more importantly length of runs in relation to the chassis ( including height dimensions).
If you then call Roger at Autosparks he will associate the correct loom for you and advise on the best materials and any extras you may wish to incorporate.
If you wish to stay 'original and use cotton covered, then you will have trouble squeezing the loom into the flexichannels etc and may need to replace the original grommets. This is not impossible but will ake patience.
An alternative is to use the modern plastic cable but still get it cotton covered.
You can then get this made ready fr the Spring.
Good luck..
Laurence,
Instead of removing the loom you can always document the loom by creating a loom tree noting where the important components are and more importantly length of runs in relation to the chassis ( including height dimensions).
If you then call Roger at Autosparks he will associate the correct loom for you and advise on the best materials and any extras you may wish to incorporate.
If you wish to stay 'original and use cotton covered, then you will have trouble squeezing the loom into the flexichannels etc and may need to replace the original grommets. This is not impossible but will ake patience.
An alternative is to use the modern plastic cable but still get it cotton covered.
You can then get this made ready fr the Spring.
Good luck..