Show whole topic
May 08, 2015 1:31 am
May 08, 2015 1:31 am
Subject: Re: Brake overhaul - levers
Hi Guys
I agree with Alec's comments - especially his comment about brazing in a sleeve being the least risky solution. As an electrical engineer I love it when a well-fluxed solder or brazing joint gets to the right temperature and the metal runs in nicely. As Alec says, this takes place at a much lower temperature than welding and you build a second sight when this is correct. This is most satisfying.
Colin
Hi Guys
I agree with Alec's comments - especially his comment about brazing in a sleeve being the least risky solution. As an electrical engineer I love it when a well-fluxed solder or brazing joint gets to the right temperature and the metal runs in nicely. As Alec says, this takes place at a much lower temperature than welding and you build a second sight when this is correct. This is most satisfying.
Colin