Show whole topic
May 21, 2015 9:49 am
May 21, 2015 9:49 am
Subject: Re: Brake overhaul - levers
I used a 1mm cutting disc on a 4.5 inch angle grinder (maybe used 2 or 3 discs in total - but only about 80p each) and then used a 40 grit flap disc on the same type of grinder (I find that a flap disc is much "kinder" to use than a hard disc).
I also cut out a large "U" shape brake pedal (about 10" X 10") by the same method.
Not too much effort involved but quite a lot of time !
I used a 1mm cutting disc on a 4.5 inch angle grinder (maybe used 2 or 3 discs in total - but only about 80p each) and then used a 40 grit flap disc on the same type of grinder (I find that a flap disc is much "kinder" to use than a hard disc).
I also cut out a large "U" shape brake pedal (about 10" X 10") by the same method.
Not too much effort involved but quite a lot of time !