Show whole topic
Dec 06, 2008 3:31 pm
Dec 06, 2008 3:31 pm
Subject: Re: SU carburettor float levels
Here is my extension ring. Now the distance from each float lid to the jet and thus the fuel level relative to the jet is the same on both sides (as far as I could check fuel level a few milimeters below the jet, which should be right, no fuel can drip in when the engine is not running)
I also attach a sketch to make it clearer.
No idea if these 10mm difference are important or not but I think it is correct now.
Attachments:
Here is my extension ring. Now the distance from each float lid to the jet and thus the fuel level relative to the jet is the same on both sides (as far as I could check fuel level a few milimeters below the jet, which should be right, no fuel can drip in when the engine is not running)
I also attach a sketch to make it clearer.
No idea if these 10mm difference are important or not but I think it is correct now.
Attachments: