Show whole topic Sep 29, 2018 8:44 pm
Registered since: Sep 23, 2018
Location: -


Subject: head 16/80
Hello,
as result of low compression between cyl 3 and 4, I found a brocken bolt an defect gasket.

So I ordered new head gasket and a set of new motor bolts at the club last week. To make sure that the defect doesn't repead, I should know the correct torque for fixing the head nuts. I found nothing in the old manual which I have.

Can someone inform meabout the correct torque in newton meters?

And by the way also the valve clearence in/out when cold?

Thanks in advance
Werner Brunner