Show whole topic Oct 19, 2018 11:49 am
davidbracey Offline
Member
Registered since: Aug 10, 2012
Location: Maidstone, Kent


Subject: Re: Kigass copper pipe
It's not a complicated thing Richard, but it is a bit fiddly. A few ball bearings, springs, a diaphragm and graphite cord top seal the shaft. I think the piston has a square section o-ring that could need replacing. Once you start stripping it you'll need to perservere though. I have some graphite cord left over from when I did the one on my Aston. You're welcome to it.

I'm by no means an expert but if there'f no resistance my guess is that the spring/ball is gummed up and will just need cleaning. I am pretty sure that some vintage tractors used these as well and that you can by a service kit. aerovintagespares.com used to sell replacements once but I've no idea if they still do.

Good luck,

David