Show whole topic Dec 16, 2018 10:57 pm
Mark Offline
Member
Registered since: Feb 05, 2009
Location: Worcestershire


Subject: M45 Distributor Skew Gear
I have discovered the skew gear on the Lucas distributor of my M45 is badly worn. There are of course two of these gears so I guess the one on the drive from the dynamo is also worn.

Could anyone advise how these gears are secured to the distributor shaft? It looks like a roll pin?

Secondly has anyone replaced these gears? I believe the part number is Lucas 421439. They available from the club. Any advice on fitting?

As ever grateful for any advice.
Mark