Lagondaforum » Other » ZE layshaft bearings

alecrb	Aug 31, 2016 6:26 am
Subject: ZE layshaft bearings I'm putting new gears and shafts in the ZE box. When I polished up the layshaft outer bearing races, I found some corrosion damage, about .0005-.001" deep. My first thought was to remake these parts, but then I went looking for an alternative. I found some needle bearings with machined outer rings that fit exactly, and the calculations show that they are more than adequate for the task. Seems like a simple solution and I wonder if anyone else has had this issue. I've attached a couple of pictures. Alec
Attachments: layshaft bearings.jpg (Filesize: 86.00 KB) ZE layshaft bearing races.jpg (Filesize: 89.24 KB)

alecrb

Aug 31, 2016 6:26 am

Subject: ZE layshaft bearings

I'm putting new gears and shafts in the ZE box. When I polished up the layshaft outer bearing races, I found some corrosion damage, about .0005-.001" deep. My first thought was to remake these parts, but then I went looking for an alternative. I found some needle bearings with machined outer rings that fit exactly, and the calculations show that they are more than adequate for the task. Seems like a simple solution and I wonder if anyone else has had this issue. I've attached a couple of pictures.
Alec

Attachments:
layshaft bearings.jpg (Filesize: 86.00 KB)
ZE layshaft bearing races.jpg (Filesize: 89.24 KB)