| randall977 | Feb 06, 2013 10:14 am |
|---|---|
|
Subject: Which battery to use? The battery compartment appears to measure L375 x W190 x H150mm, most car batteries are a minimum of 175mm high - am I mis-measuring the available space (taking into account the fibreglass lid) or do you have to get a very low battery? |
|
| David | Feb 06, 2013 2:13 pm |
|---|---|
|
Subject: Re: Which battery to use? The battery may well sit proud of the compartment, hence the raised lid, about another 25 mm. Fit the biggest Ampere-Hour you can find with the terminals in the right place for the leads (positive on forward outboard side if I recall) |
|
| randall977 | Feb 06, 2013 2:56 pm |
|---|---|
|
Subject: Re: Which battery to use? The metal section is about 4" (100mm) deep excluding the base board and the fibreglass section is about 2" (50mm) - so obviously together that's 150mm. Lucas do a simular battery which is L350 x H175 x W175mm - 95Ah - the hight appears to be the problem. The position of the terminals won't matter as I'm reversing the polarity and fitting a new earth via the isolation switch. |
|
| David | Feb 06, 2013 5:14 pm |
|---|---|
|
Subject: Re: Which battery to use? Sounds as if your battery compartment is shallower than on my car, where the metal section looks (from memory) 6-7 inches deep above the base board |
|
| randall977 | Feb 06, 2013 10:18 pm |
|---|---|
|
Subject: Re: Which battery to use? Just re-measured from under and I think 175mm will just fit... |
|