| alistair | Apr 19, 2008 6:51 pm |
|---|---|
|
Subject: Delco Remy Distributor - removing cap My V12 saloon has Delco Remy distributors and I would like to check and clean the contact points. However when I undo the metal side clips, the distributor cap does not pop off to reveal the points - what else holding it on? I can see plenty of things to fiddle with, but thought I would appeal to the wisdom of the forum before risking damage. |
|
| Peter S30 | Apr 19, 2008 7:08 pm |
|---|---|
|
Subject: Re: Delco Remy Distributor - removing cap Dear Alistair, the Delco in my V12 are only hold by the 2 clips. Sometimes you have to give it a slight knock with your hand to get it off because it is sticking a bit. |
|
| alistair | Apr 20, 2008 8:36 am |
|---|---|
|
Subject: Re: Delco Remy Distributor - removing cap Thanks - that is what I thought but it did not move with a little pressure. Will do what you recommend. |
|
| alistair | Apr 21, 2008 5:00 pm |
|---|---|
|
Subject: Re: Delco Remy Distributor - removing cap It took a very firm tap to release it - more pressure than I would have applied without your advice - thanks. |
|