Lagondaforum

Hello Guest! (New posts) Forum


Expand and collapse Topic Options
Pages (1): [1]
 Show first unread post

Aug 31, 2016 6:26 am
alecrb Offline
Member
Registered since: Dec 05, 2007
Location: Vancouver, Canada


Subject: ZE layshaft bearings
I'm putting new gears and shafts in the ZE box. When I polished up the layshaft outer bearing races, I found some corrosion damage, about .0005-.001" deep. My first thought was to remake these parts, but then I went looking for an alternative. I found some needle bearings with machined outer rings that fit exactly, and the calculations show that they are more than adequate for the task. Seems like a simple solution and I wonder if anyone else has had this issue. I've attached a couple of pictures.
Alec


Thumbnails of attached images:

Filename: layshaft bearings.jpg
Filetype: File Type Information for: jpg jpg
Downloads: 797
Filesize: 86.00 KB
Image size: 800 x 317 Pixels

Filename: ZE layshaft bearing races.jpg
Filetype: File Type Information for: jpg jpg
Downloads: 793
Filesize: 89.24 KB
Image size: 800 x 351 Pixels


Alec Rivers-Bowerman
 

Pages (1): [1]


All times are GMT