Lagondaforum

Subject: Wanted Special Ring Spanner To Fit T8 Locknut

---

Part is listed and pictured on the Club website as #GRS432 but may be out of stock. Need a few of these as well. I have been told Rolls used a lot of these type of nuts as well so is it possible a Rolls spanner will work?

---

Subject: Re: Wanted Special Ring Spanner To Fit T8 Locknut

---

Hi Barry,

I made one of these spanners on my milling machine which has a rotary table. I suggest you get a local machinist to do the same from a length of tube. Don't forget that it is a left hand thread.

Colin

Subject: Re: Wanted Special Ring Spanner To Fit T8 Locknut

---

Thanks Colin, Now that I know such a tool is rare I will make one. Barry

---