Lagondaforum

Hello Guest! (New posts) Forum


Expand and collapse Topic Options
Pages (1): [1]
 Show first unread post

Apr 19, 2008 5:51 pm
alistair Offline
Member
Registered since: Dec 04, 2007
Location: -


Subject: Delco Remy Distributor - removing cap
My V12 saloon has Delco Remy distributors and I would like to check and clean the contact points. However when I undo the metal side clips, the distributor cap does not pop off to reveal the points - what else holding it on? I can see plenty of things to fiddle with, but thought I would appeal to the wisdom of the forum before risking damage.
Alistair Crawford
 

Apr 19, 2008 6:08 pm
Peter S30 Offline
Member
Registered since: Nov 27, 2007
Location: Germany


Subject: Re: Delco Remy Distributor - removing cap
Dear Alistair,

the Delco in my V12 are only hold by the 2 clips. Sometimes you have to give it a slight knock with your hand to get it off because it is sticking a bit.
 

Apr 20, 2008 7:36 am
alistair Offline
Member
Registered since: Dec 04, 2007
Location: -


Subject: Re: Delco Remy Distributor - removing cap
Thanks - that is what I thought but it did not move with a little pressure. Will do what you recommend.
Alistair Crawford
 

Apr 21, 2008 4:00 pm
alistair Offline
Member
Registered since: Dec 04, 2007
Location: -


Subject: Re: Delco Remy Distributor - removing cap
It took a very firm tap to release it - more pressure than I would have applied without your advice - thanks.
Alistair Crawford
 

Pages (1): [1]


All times are GMT