Subject: Keys for the Rapide
When I first approached several AM dealers and also ASD, I was told it was not possible to have keys cut for my car locks, since these were special locks, and I would need to get some locks made.
Well I ignored this advice, I stripped the locks down myself, and they are relatively simple Yale locks.
Here is a simple picture of the internal part of the ignition barrel:
http://www.yorklock.com/cylinder.htm
I have now had keys cut for my Rapide ignition and glove box.
I also attach a picture of the relay for the ignition and a simple wiring diagram if any of your wires come loose. Please do note that positions 1 and 3 on the relay are reversed to that used on the DB4. (If anyone needs this, happy to email over a clearer picture).
Wiring colors as follows: WR is predominate white with red minor; NW is predominate brown with white minor; P is purple.
A small point, when re-assembling, remember to put back the key way between the ignition barrel and the relay. otherwise, the key wil keep turning in the lock...
I now have an ignition key and glove box keys, pictures are shown.
Will remove my door lock and boot lock next, and then will have a full set of keys.
If anyone needs any help with keys or advice, please email over, happy to help.
Thumbnails of attached images:
Filename: a.jpg
Filetype: jpg
Downloads: 284
Filesize: 36.02 KB
Image size: 1440 x 945 Pixels
Filename: c.jpg
Filetype: jpg
Downloads: 289
Filesize: 78.27 KB
Image size: 1671 x 960 Pixels
Filename: d.jpg
Filetype: jpg
Downloads: 299
Filesize: 31.76 KB
Image size: 1500 x 1091 Pixels
Filename: Igntion relay b.jpg
Filetype: jpg
Downloads: 298
Filesize: 76.47 KB
Image size: 1500 x 1421 Pixels
This post has been edited
4
times. Last edit on May 24, 2012 10:48 am by SRD.