Lagondaforum

Hello Guest! (New posts) Forum


Expand and collapse Topic Options
Pages (1): [1]
 Show first unread post

Nov 12, 2013 5:14 am
garand69 Offline
Member
Registered since: Jul 27, 2013
Location: -


Subject: New Oil Pump 2.6

HELLO
MY EGINE OIL PUMP IS USED
I BUY A NEW OIL PUMP

Have you made any changes to your lubrication system in the engine
if so, which?

thank you for all the information and photos

best regards

Cyril carré (France)
 

Nov 12, 2013 10:29 pm
ray sherratt Offline
Member
Registered since: Jul 05, 2012
Location: wirral cheshire


Subject: Re: New Oil Pump 2.6
Have you checked the oil clearances, the gear/rotor end float
should be .002"to.004" of an inch. The gear/rotor to body
clearance should be .004"to.010" max. New pumps are expensive
but you can have your old one rebuilt. At the moment I have
7 Feltham engines in rebuild, two for Hans Natens of Belguim.

Ray Sherratt.
 

Nov 13, 2013 3:41 am
garand69 Offline
Member
Registered since: Jul 27, 2013
Location: -


Subject: Re: New Oil Pump 2.6
Hello

pump heavy scratches in the body and play in the gears

I am interested in retrofitting a pump if possible

how should I do?

I have received proposals for new pumps. providers indicate a flow and a higher pressure.
there are changes to the cannaux grease, body oil filter
and the oil supply pipes that extend crankshaft
there is a change on the camshaft but I do not understand
if you are interested in these changes sent me an email directly I will pass them on.
 

Nov 14, 2013 9:45 pm
ray sherratt Offline
Member
Registered since: Jul 05, 2012
Location: wirral cheshire


Subject: Re: New Oil Pump 2.6
There is work on the block to reduce the unwanted back presure which destroys the scew gear drive. The face
that the pump bolts to needs to be opened to match the
exit opening the oil pump. The hole needs to be milled to
the depth of the transfer port below, preferabley with
a bull nosed cutter, or blended with a die grinder. Next
the transfer holes forward, and the two to the oil filter
tower, all need to be bored/drilled to 14mm. Be careful
on braking through into the the transfer drilling, not to
touch the oil presure relief valve port oposite. Next the
oil pump tower needs the same tretment. These operations
will require tapping for larger end plugs. The oil filter lower
and upper holes at 90deg to the vertical holes, need to be checked to make sure they line up to the block and the
filter housing. Make sure the gaskets don`t mask the
drillings. Last of all if you have the old rotary oil filter
copper screen type they can be coverted to a modern
paper type.

Ray.
This post has been edited 1 times. Last edit on Nov 14, 2013 9:47 pm by ray sherratt.  

Pages (1): [1]


All times are GMT